Tabla de contenido
Idiomas disponibles
Idiomas disponibles
5.2 - Controls function
ATTENTION: the impeller turns on automatically when the machine (turned ON)
remains immersed in water which has a temperature of 40 ° C upwards (ref. 7
Fig. N°2).
Warning: before switching the machine on, place it on the tank reserved for cooking,
secure it with the clamp (Ref. 9 - Fig. 5) then fill the tank with water, while taking care
to observe the minimum and maximum levels (Fig. 5).
A. Procedure
-
Switch the machine on by shifting the switch (Ref. 12 - Fig. 2) to ON.
-
Press the + or - button to select the desired processing programme.
-
Press the > button to start the process.
Modifying the temperature without stopping the program in progress:
-
Press the DISPLAY button: the display will show the temperature relative to the
current programme and the corresponding LED will start flashing.
-
Use the + and - buttons to modify the desired temperature.
-
The changes just made are temporary and will be valid until STOP, they will not be
saved in the program in use.
B. Infinite-time programme
This programme entails the setting of the temperature while the time is infinite:
-
Press the MENU button and then >.
-
Press the DISPLAY button to enter the desired temperature using the + and - but-
tons: the set data will last until the STOP.
-
The machine can be stopped at any time by pressing the O button.
C. Delayed start
-
Choose the desired programme and then press the MENU button to set the start
delayed by 10 minutes to 24 hours with 10-minute steps, using the + and - buttons.
-
The display will show the countdown to the start of the programme.
-
The time and temperature LEDs will flash until the set time has expired.
D. Personalisation of the 25 pre-set programmes
A. Switch the machine on by shifting the switch (Ref. 12 - Fig. 2) to ON.
B. With the machine in STOP mode, select the desired programme using the + and -
buttons.
C. Press the MENU button for 4 seconds.
D. The temperature LED will flash, then the data can be modified using the + and -
buttons.
E. Press the DISPLAY button to switch to the time adjustment function.
F. The time LED will flash, then the data can be modified using the + and - buttons.
G. To save the modified data, press and hold for 4 seconds the MENU button or wait
10 seconds and the data will be saved automatically.
Once the chosen temperature has been reached and at the end of each work
cycle, the machine emits a BEEP.
12
Tabla de contenido
