Connection Instructions - Nexgrill 820-02003 Manual Del Propietário

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

GAS HOOK-UP
Only the pressure regulator and hose assembly supplied with the pizza oven should be used. Any replacement pressure
regulator and hose assembly must be specified by the pizza oven manufacturer. This pizza oven is configured for liquid
propane (LP). Do not use a natural gas supply.
Total gas consumption (per hour): 14,000 BTU/HR
The installation of this appliance must conform with local codes or, in the absence of local codes, with either the National
Fuel Gas Code, ANSI Z223.1/NFPA 54, National Gas Propane Installation Code, CSA B149.1, or Propane Storage and Handling
Code, B149.2,or the Standard for Recreation Vehicles, ANSI A119.2/NFPA 1192, and CSA Z240 RV Series, Recreation Vehicle
Code, as applicable.
For use with a standard 9 kg (20 lb) propane (LP) cylinder: 470 mm (18 1/4 in) high, 305 mm (12 1/4
in) diameter. A dented or rusty liquid propane cylinder may be hazardous and should be checked
by your supplier. Never use a cylinder with a damaged valve. The liquid propane cylinder must be
constructed and marked in accordance with the specifications for liquid propane cylinders by
the United States Department of Transportation (DOT) or the National Standard of Canada, CAN/
CSA-B339, Cylinders, Spheres and Tubes for Transportation of Dangerous Goods Commission.
The 9 kg (20 lb) cylinder must have a shut-off valve terminating in a valve outlet specified, as
applicable, for connection type QCC1 in the standard for compressed gas cylinder valve outlet and
inlet connection ANSI/CGA-V-1.
Storage of an outdoor cooking gas appliance indoors is permissible only if the cylinder is
disconnected and removed from the outdoor cooking gas appliance. The cylinder system must be
arranged for vapour withdrawal. The cylinder must include a collar to protect the cylinder valve.
Manifold pressure: (operating) 27.9 cm (11 in) water column, (non-operating) 28.4 cm (11.2 in) water
column. The liquid propane cylinder must be fitted with an overfill protection device (OPD).
If fitted, remove the plastic valve cover from the liquid propane cylinder. Make sure the gas hose
does not contact the pizza oven when the liquid propane cylinder is positioned.
WARNING:
NEVER ATTEMPT TO USE DAMAGED OR OBSTRUCTED EQUIPMENT. SEE YOUR LOCAL LIQUID PROPANE
(LP) DEALER FOR REPAIR.
REPLACING THE LIQUID PROPANE (LP) CYLINDER
Turn the pizza oven gas valve knob (right knob) clockwise to the OFF () position and make sure the pizza oven is cool.
Turn the liquid propane (LP) cylinder valve to the CLOSED position by turning clockwise until it stops.
Detach the regulator assembly from the cylinder valve by turning the quick-coupling nut counterclockwise. Cover the regulator
connector with its protective plug.
Place dust cap on cylinder valve outlet whenever the cylinder is not in use. Only install the type of dust cap on the cylinder valve
outlet that is provided with the cylinder valve. Other types of caps or plugs may result in leakage of propane.

CONNECTION INSTRUCTIONS

LIQUID PROPANE (LP) CYLINDER REQUIREMENTS
CONNECTING THE LIQUID PROPANE (LP) CYLINDER
9 KG (20 LB) CYLINDER
8
Tabla de contenido

Solución de problemas

loading

Tabla de contenido