Filter Change - IPC FOX Manual De Instrucciones

4.3 Responsibility
IP Cleaning disclaims all responsibility
for all damage caused by incorrect
use or modification of the machine.

4.4 Filter change

The pre-filter (11) and post-filter (6)
can be worn and need to be replaced.
For cleaning of post-filter see 3.4
Pre-filter (11) change:
1. Turn off the vacuum cleaner
2. Remove the plug from the
wall socket
3. Remove the head from the
tank
4. Position
down
5. Remove the 4 screws fixing
the filter frame to the head
6. Remove the filter
7. Insert the new filter into the
filter frame and place it on
the head
the head upside
8. Fix the 4 screws. Do not over
tighten the screws.
9. Check the filter is properly fixed
and the sealing between head and
filter frame is secured.
5. Trouble shooting
Repair or service of electrical
components such as cord or
motor, must only be carried out
by an authorized service centre.
If the machine does not start
• Check that the plug is correctly
fitted to the wall socket.
• A fuse in the building may have
blown and needs to be changed.
• The cord
damaged and must be repaired
by an authorized service centre.
Reduced suction power
• The tank (2) may be full and
needs
instructions.
• The pre-filter
blocked and have to be cleaned,
see chapter 3.2
• The bent tube, hose, tube or
nozzle may be blocked and
needs to be cleaned.
6. Noise
Values measured according to :
EN 60704 - 1 (1997) / EN 60704 -2 - 1
(2001) rules.Measurement A for the
sound pressure level of the machine is
<80dB(A) Under unfavourable feed
conditions, the appliance may cause
temporary drops in voltage.
22
or plug may
to be emptied,
(11) can
EN
be
see
be