Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Removing the battery
The battery is equipped with two locking levels
that should prevent the battery from falling out
when pushing the battery unlocking button
unintentionally. As long as the battery is inserted
in the power tool, it is held in position by means
of a spring.
To remove the battery , press the unlocking
button and pull out the battery toward the front.
Do not exert any force.
Changing the Tool (see figure A)
•
Before any work on the machine itself (e.
g. maintenance, tool change, etc.) as well
as during transport and storage, remove the
battery from the power tool. There is danger
of injury when unintentionally actuating the On/
Off switch.
Open the keyless chuck by turning in rotation
direction (1) , until the tool can be inserted. Insert
the tool.
Firmly tighten the collar of the keyless chuck
by hand in rotation direction (2) .
This automatically locks the drill chuck.
Dust/Chip Extraction
•
Dust from materials such as lead containing
coatings, some wood types, minerals and
metal can be harmful to one's health and
cause allergic reactions, lead to respiratory
infections and/or cancer. Materials containing
asbestos may only be worked by specialists.
– Provide for good ventilation of the working
place.
– It is recommended to wear a P2 filterclass
respirator. Observe the relevant regulations in
your country for the materials to be worked.
•
Prevent dust accumulation at the workplace.
Dust can easily ignite.
Operation
Starting Operation
Inserting the battery
Note: Use of batteries not suitable for the
machine can lead to malfunctions of or cause
damage to the power tool. Set the rotational
direction switch to the centre position in order to
avoid unintentional starting. Insert the charged
battery into the handle so that it can be felt to
engage and faces flush
against the handle.
Reversing the rotational direction (see figure B)
The rotational direction switch is used to reverse
the rotational direction of the machine. However,
this is not possible with the On/Off switch
actuated.
Rotate clockwise: Move the rotational direction
switch on both sides up to the stop into position.
Rotate anticlockwise: Move the rotational
direction switch on both sides up to the stop into
position .
Setting the operating mode
Drilling
Set the operating mode selector switch to the
"drilling" symbol.
Scandriver
Set the torque selector setting ring to the
"screwdriving" symbol.
Impact drilling
Set the operating mode selector switch to the
"impact drilling" symbol.
Switching On and Off
To start the machine, press the On/Off switch
and keep it pressed.
The LED lights up when the On/Off switch is
halfway or fully pressed, and enables illumi-
nation of the screwing location in unfavorable
light conditions.
Adjusting the Speed
The speed of the switched-on power tool can be
variably adjusted, depending on how far the On/
Off switch is pressed.
Light pressure on the On/Off switch results in
a low rotational speed. Further pressure on the
switch results in an increase in speed. Setting the
torque
With the torque preselection ring , the required
torque can be preselected in 17 steps. The
inserted tool is stopped as soon as the set torque
is reached.
Gear selection, mechanical
•
The gear selector can be actuated at standstill
or when the machine is running. However, this
should not be done while operating at full load or
maximum speed.
1st gear:
Low speed range; for working with large drilling
diameters.
8
Tabla de contenido
