Maintenance And Cleaning - Antar AT52323 Manual De Usuario

Shifter
The direction of travel and speed of the electric wheelchair are controlled by pressing the control lever;
Power switch / lock key
2 seconds long press turn on the power, long press 2 seconds turn off the power;
Pressing the power button will turn off the wheelchair's electric lock indicator and the wheelchair will unlo ck
Press the power button, the electric wheelchair lock indicator will be displayed and the electric wheelchair will be locked
"Speed +" button
Pressing the button increases the speed;
* To set a constant cruising speed, hold down the "speed +" button for a longer time, then push the lever forward to activate the cruise control
"Speed-" button
Pressing the button reduces the speed;
Beep button
A short press of the beep button will trigger the beep. Sound intensity meets national noise standards;
Electric trolley lock status indicator light
Turning on the power automatically activates the lock. Re-activation of the lock is possible at any time while using the device;
When the lock is engaged, the wheelchair will not respond to movement of the joystick. When the lock is released, deflecting the control stick will cause the wheelchair to move.
When using the application, information about the lock status will be displayed.
SOS emergency button
Holding the button down for 3 seconds will trigger an alarm signal
Start-up button for a beginner
The driving parameters of the electric wheelchair will be automatically adjusted to the speed and parameters adapted to the learners.
Switching the truck to manual mode
Press the "+" button and the "-" button simultaneously to put the truck into manual drive mode. Move the control lever to exit manual drive mode.
BATTERY
Removing the battery
1 - Open the battery lock located on the housing of the trolley
2. Pull out the battery
Battery lock latch
CHARGING THE ELECTRIC FORKLIFT
Charging method 1: Connect the charger and then plug it into the port on the bottom of the controller
Charging method 2: Remove the battery compartment and connect the charger to the charging port located inside the battery compartment

MAINTENANCE AND CLEANING

• We recommend regular (weekly or monthly - depending on frequency of use) inspection of fasteners such as bolts and nuts for possible loosening, possible corrosion etc
.;
• Regularly check the moving parts of the joint for binding, falling, etc .;
• Regularly check the tires for signs of wear, etc;
• When using a wheelchair in rain or humid weather, wipe the device dry as soon as possible to prevent rust formation;
• Avoid exposing the electric wheelchair to excessive sunlight in high temperature conditions.
• Cleaning the electric wheelchair: Wipe the surface of the wheelchair with a clean, soft cloth.
TROUBLESHOOTING
When calling the service, have the fault code ready.
The product is equipped with an automatic diagnosis system, thanks to which a fault code is displayed
The fault
The nature of the fault
code
E1 Button malfunction
E2 Lever malfunction
E3 GPRS failure
E4 Battery failure
E5 Relay error
E6
Accessory fault
E7 Bluetooth malfunction
E8 Engine error
E9 Drive error
EA FLASH failure
2
1
Emergency signal
Emergency signal
Emergency signal
Emergency signal
Emergency signal
Emergency signal
Emergency signal
Emergency signal
Emergency signal
Emergency signal