Power Supply - DeWalt DXAE20VBB Manual De Instrucciones

Power Supply

The D WALT 20V Battery Pack is an optional accessory.
®
e
This unit is powered exclusively by the D
(optional accessory). It must be fully recharged via the compatible
D WALT dedicated Battery Charger (optional accessory). Refer to the
®
e
corresponding instructions included with the Battery Pack and Charger.
In order to operate this Vehicle Battery Charger, the fully charged
D WALT 20V Battery Pack must be properly installed into the 20V
®
e
battery terminal connector on the back of unit. Make sure the D
20V Battery Pack is properly locked into the battery pack terminal
connector (N) (as shown in Figure 2b).
Chargers
• D WALT ® 20V Battery Packs use D
e
read all safety instructions before using the charger.
• Consult the chart at the end of this manual for compatibility of
chargers and D WALT 20V battery packs.
®
e
CHARGING PROCEDURE
1. Plug the charger into an appropriate
outlet before inserting the D
battery pack.
2. Insert the battery pack (O) into the
charger (P), as shown in Figure 3,
making sure the pack is fully seated in
charger. The red (charging) light will blink
continuously, indicating that the charging
process has started.
3. The completion of charge will be
indicated by the red light remaining ON
continuously. The pack is fully charged
and may be used at this time or left in
the charger.
WALT 20V Battery Pack
®
e
e
WALT chargers. Be sure to
e
(Fig. 3)
WALT 20V
®
e
P
Operating Instructions
Automotive Charging Using the
Included Battery Clamps
PREPARING TO CHARGE
1. Determine voltage of vehicle battery by referring to car owner's
manual and make sure it matches output rating of Vehicle Battery
WALT
®
Charger (12V).
2. If necessary to remove battery from vehicle to charge, always
remove grounded terminal from battery first. Make sure all
accessories in the vehicle are off, so as not to cause an arc.
3. Be sure the area around the vehicle battery is well-ventilated while
the vehicle battery is being charged.
4. Clean the vehicle battery terminals, Be careful to keep corrosion
from coming in contact with eyes.
5. For non-maintenance-free batteries, add distilled water in each
cell until battery acid reaches the level specified by the battery
manufacturer. This helps purge excessive gas from cells. Do
not overfill. For a battery without removable cell caps, such as
valve regulated lead acid batteries, carefully follow manufacturer's
recharging instructions.
6. STUDY ALL BATTERY MANUFACTURER'S SPECIFIC
O
PRECAUTIONS, SUCH AS REMOVING OR NOT REMOVING
CELL CAPS WHILE CHARGING, AND RECOMMENDED RATES
OF CHARGE.
CHARGER LOCATION
• Locate the charger as far away from the vehicle battery as DC cables
permit.
• Never place the charger directly above the vehicle battery being
charged; gases from the battery will corrode and damage the charger.
10