Service Information - DeWalt DXAEOBD Manual De Instrucciones

Troubleshooting
Problem Possible Solution
The unit will Connect unit to the OBD-II port,
not charge the
Ensure good contact between the OBD-II plug
vehicle battery
and OBD-II outlet.
The voltage of the vehicle battery is too low.
The Charge Status/Fault Indictor will flash
rapidly for 60 seconds before the Battery
Charger automatically shuts down.
The vehicle battery may in fault condition and
cannot accept the charging. Manufacturer
recommends taking it to a certified automotive
service center for evaluation.
The voltage of the D
may be low. The Charge Status/Fault Indicator
will flash rapidly for 60 seconds before
the Vehicle Battery Charger automatically
shuts down. Disconnect the Vehicle Battery
and fully charge the D
Pack, following the directions included with
the dedicated D
Charger.
If the D WALT
e
or is too cold, the Charge Status/Fault Indictor
will flash rapidly for 60 seconds before the
Battery Charger automatically shuts down.
Disconnect the Battery Clamps and allow the
unit to cool down or warm up for a period
before resuming any operation.
WALT 20V Battery Pack
®
e
WALT 20V Battery
®
e
WALT 20V Battery Pack
®
e
20V Battery Pack is overheated
®
Accessories
WARNING:
Since accessories, other than those offered by
manufacturer, have not been tested with this product, use of such
accessories with this unit could be hazardous. To reduce the risk of
injury, only manufacturer-recommended accessories should be used
with this product.
If you need assistance regarding accessories, please contact the
manufacturer at 1-888-394-3392 or CustomerService@dewalt12volt.
com.

Service Information

Whether you need technical advice, repair, or genuine factory
replacement parts, contact the manufacturer at 1-888-394-3392 or
[email protected].
One Year Limited Warranty
The manufacturer warrants this product against defects in material
and workmanship for a period of one (1) year from the date of retail
purchase by the original end-user purchaser ("Warranty Period").
If there is a defect and a valid claim is received within the Warranty
Period, the defective product can be repaired, replaced or refunded,
without charge, in the following ways: (1) Return the product to the
manufacturer for repair, replacement or refund at manufacturer's option.
Proof of purchase may be required by manufacturer. (2) Return the
product to the retailer where product was purchased for an exchange
(provided that the store is a participating retailer). Returns to retailer
should be made within the time period of the retailer's return policy for
exchanges only (usually 30 to 90 days after the sale). Proof of purchase
may be required. Please check with the retailer for their specific return
policy regarding returns that are beyond the time set for exchanges.
This warranty does not apply to: accessories, bulbs, fuses and
batteries; defects resulting from normal wear and tear, accidents;
12