Sensica IPL300 Serie Manual Del Usuario página 15

3. Select the desired
treatment window and
simply snap it onto the
device by aligning the
plastic pins of the selected
window to the device
sockets and pressing
into place. To remove
the treatment window,
grab both sides on the
elevated dots and firmly
pull until it is removed.
4. Place the treatment
window on the desired
treatment area, ensuring
full contact with the skin.
As a safety precaution
the device is equipped
with a safety sensor that
will not trigger a flash if:
• The device is not
properly applied to the
skin. In this case, the
status indicator will turn
"momentarily" orange.
• Your skin tone is too dark/
tanned. In this case, the
status indicator will turn
"momentarily" red.
• The treatment
window is not properly
attached. In this case,
the status indicator
will turn "steady" red.
5. Apply the treatment
window firmly against your
skin and press the trigger
button to release a flash.
Following each flash, move
the device to the next spot.
After each flash, the device
will take 1-3 seconds to be
ready for the next one.
6. You may choose from 2
operational modes, the
'Pulse mode' or the
'Glide mode':
• Pulse mode: Press the
trigger button once to
release a single flash.
Continue to the next
spot and press the
trigger button again
to release another
flash. Repeat this until
treatment is complete.
• Glide mode: Begin
treatment in Pulse mode.
After three consecutive
flashes without releasing
the trigger button, the
device will automatically
enter the Glide mode. This
mode will release flashes
continuously, with a 1-3
second pause between
each one, so there is
no need to hold the
trigger button. The Glide
mode will automatically
15