Lighting Instructions; Cleaning And Maintenance - MaxxGarden 21967 Manual De Usuario



LIGHTING INSTRUCTIONS

Check and ensure that an AA battery is inside the ignition chamber and
has power. Ensure the anode(+) faces outside.
1. Ensure that the control knob is OFF. Slowly open the gas cylinder valve.
2. Press and turn the control knob to LIGHT position, push the igniter to
generate spark while keeping control knob in pressed position.
3. Check for pilot flame through glass tube. If pilot does not light, turn control
knob to 'OFF' position wait two minutes minimum and try again from
the start. Some attempts may be necessary.
4. If the pilot alight, keep control knob pressed for 15 seconds then turn
the control knob to 'LOW'.
5. For maximum heat turn control knob to 'HIGH'.
6. To turn heater off, turn control knob to 'OFF'.
7. Close the valve of the gas cylinder or the regulator after use.

CLEANING AND MAINTENANCE:

● To ensure outstanding performance of your heater make sure to perform
the following maintenance activities on a regular basis:
● Keep exterior surfaces clean.
- Use warm soapy water for cleaning. Never use flammable, corrosive or abrasive cleaners.
- While washing your unit, be sure to keep the area around the burner and pilot assembly dry
at all time. If the gas control is exposed to water in any way, do NOT use it. It must be replaced.
● Before use the unit should be inspected for spiders, spider webs or other insects.
● Air flow must be unobstructed. Keep controls. Burner and circulating air passageways clean.
Signs of possible blockage include:
- Gas odor with extreme yellow tipping of flame.
- Heater does NOT reach the desired temperature.
- Heater glow is excessively uneven.
- Heater makes popping noises.
- Compressed air may help clear away smaller particles.
● Carbon deposits can create a fire hazard. Clean reflector and glass tube inside with soapy
water if any carbon deposits develop. Always be careful when cleaning the glass tube.
STORAGE:
Between uses:
● Turn the control knob to "OFF" position.
● Turn LPG cylinder to "OFF" position.
● Store heater upright in an area sheltered away from weather conditions (such as rain, sleet, hail,
snow).
● If desired, cover heater to protect exterior surfaces and to help prevent dust and debris
collecting in air passages.
During periods of extended inactivity or when transporting:
● Turn the control knob to "OFF" position.
● Disconnect LPG Cylinder and move to a secure, well-ventilated location outdoors.
DO NOT store in a location that will exceed 50 degrees C.
● Store heater upright in an area sheltered away from weather conditions (such as rain, sleet, hail,
snow).
● If desired, cover heater to protect exterior surfaces and to help prevent dust and debris
collecting in air passages.
WARNING
FOR YOUR SAFETY:
● DO NOT touch or move heater for at least 45 minutes after use.
● Allow all burner elements to cool before touching.
NOTE
● In a salt-air environment (such as near an Ocean) corrosion occurs more quickly than normal.
● Frequently check for corroded areas and repair them promptly.
● Wait until heater is cool before covering.





10
OFF
LIGHT
LOW
HIGH
10
41