Advance the saw with little force.
Support
Fig.4
Cutting holes: possible only in chipboard and wood unless you drill a hole first. Press the jigsaw firmly against
the support and move slowly in cutting direction.
Parallel guide
Use the supplied parallel guide to saw parallel to the edge of the workpiece.
1. Loose the finger screws on the front of the base plate.
2. Insert the parallel guide from the side in the slot in the base plate.
3. Lock the parallel guide in the required position with the finger screws.
4. Adjust the required cutting width in centimeter by putting the corresponding value on the scale by the
laser on the base plate.
5. Tighten the finger screws with your finger.
Blow button (Fig.5)
The blow button, it marked "off↔on" under the button.
Fig.5
The tool is in blow mode when the blow button is in the "on" position. The blow function is activated by
pressing the power switch.
The dust extraction function is activated when the blow button is in the "off" position.
LED light
The LED light will light when you press the on/off trigger.
Dust extraction
The jig saw is equipped with a dust extractor socket. Any vacuum cleaner can be connected to the socket
at the rear of the jig saw. If you require a special adapter, please contact the manufacture of your vacuum
cleaner.
Maintenance and Service
WARNING: Before any work on the machine, pull the mains plug from the power source.
Only use accessories and spare parts recommended by the manufacturer. If the equipment should fail some
day in spite of our quality controls and your maintenance, only have it repaired by an authorised electrician.
If the carbon brushes need to be replaced, have this done by a qualified repair person (always replace the
two brushes at the same time.
If the supply cord is damaged, it must be replaced by the manufacturer or its service anent in order to avoid
a hazard. Disconnect from the power supply immediately if the supply cord is damaged.
Clean
For safe and proper working, always keep the machine and ventilation slots clean.
Clean dust and debris from vents, Keep the tool handles clean and free of oil or grease, Use only mild soap
and a damp cloth to clean your tool since certain cleaning agents and solvents are harmful to plastics and
other insulated parts. Never use flammable or combustible solvents around tools.
Blow
buttoh
05