ENGINDOT PJS02A Instrucciones De Uso página 8

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Speed adjustment
The speed can be set with the knob up on the tool. There are six different speeds. Position 1 sets the lowest
speed, and position 6 the highest. Hold the handle and turn the speed control to the required position with
your thumb.
Setting the Pendulum
For soft materials (wood, plastic etc.) set the oscillation to position 2 or 3.
For sharp-edged cuts, set the oscillation to position 0 or 1.
For medium-hard materials (hard wood, aluminum etc.) set the oscillation to a suitable position for the
application.
For thin workpiece, set the oscillation to position 0 or 1.
For hard materials (steel etc.) set the oscillation to position 0.
For round cuts, set the oscillation to position 0.
Mounting the saw blade (Fig.2)
Fig.2
Attention: The saw blade will become very hot during cutting due to friction. Pay attention for that when
removing the saw blade.
Protect yourself with protective gloves if necessary.
Adjusting the base (Fig.3)
For mitering and sawing near edges.
For miter and bevel cuts you can swivel the base by up to 450 in either direction after undoing the two screws
on the bottom. The angles 15°, 30° and 45° are marked but you can adjust the saw to any angle between
these markings as required.
Fig.3
To adjust the cutting angle, loose the two screws until you can just about move the base and adjust to the
required angle, then re-tighten the two screws.
To enable you to saw right up to the edge, the base can be pushed backward. Loose the two
screws underneath and push the base back. Then re-tighten the two screws.
It is prohibited to use the machine on asbestos materials. Please note the accident prevention regulations in
force in you country.
Cutting veneered chipboard (Fig.4)
Use a fine saw blade.
Position the base on the uncovered area
Disconnect the tool from the mains. A special handle ensures quick
mounting.
Mount the saw blade
1. Push the handle and keep the holder in open position.
2. Insert the saw blade up to the end into the saw blade holder and
release the handle. Make sure the saw blade is touching the guide
Handle
roller.
3. Slightly pull the saw blade to ensure firm fit.
Remove the saw blade
Push the handle and keep the holder in open position, then pull out
the saw blade.
Turn to right
Turn to left
04
Tabla de contenido
loading

Tabla de contenido