TALAMEX X Serie Manual De Instrucciones página 29

Transom Mount Installation
Note: The X MODELS trolling motor will fit transoms up to 68mm tick.
1. Place the trolling motor on the transom of the boat.
2. Tighten the transom clamp screws securely by hand. Do not overtighten the transom clamp screws.
IMPORTANT: Overtightening the transom clamp screws can weaken or damage the mount bracket.
Stowing and Deploying the Trolling Motor
Rotating propellers can cause serious injury or death. Never start or operate the motor out of water.
STOWING THE TROLLING MOTOR
Moving parts, such as hinges and pivot points, can cause serious injury. Keep away from moving parts when stowing, deploying,
or tilting the motor.
1. To change the drive angle or tilt the trolling motor, push down on the tilt lock release lever while simultaneously pulling on the
trolling motor head/column. Do not exert downward force on the tiller handle to assist in tilting the trolling motor.
2. When the desired tilt position is achieved, release the tilt lock release lever. Verify that the latch pin is securely engaged.
a – transom clamp screws
b – mount bracket
! WARNING
! CAUTION
Tilt lock release lever
a
b
a – �lt lock release lever
b – latch pin
a
b
29