Troubleshooting - SATA minijet 1000 K RP Instrucciones De Servicio

Operating Instructions SATAminijet 1000 K RP, SATAminijet 1000 H RP
US US
9.5. Replacing the Sealing (air side)
• Disconnect spray gun from the compressed air circuit!
Steps: [10-4], [10-5], [10-6], [10-7], [10-6], [10-5] and [10-4]
Replacing the self-adjusting seal [10-7] is required when air leaks from
under the trigger.
1. After disassembly, please check air piston rod [10-8] and clean it, if
required. If damaged (e.g. if scratched or bent), replace it and grease
with SATA high performance spray gun grease (Art. No. 48173) and
insert. Please observe correct order of installation!
After installation, please adjust material flow according to chapter 7.2.
• Check if locking screw has been firmly tightened! Air micrometer could
shoot out from the spray gun uncontrolled!
9.6. Replacing the spindle of round/flat spray con-
trol
The spindle has to be replaced when air leaks from the spray control or
when the spray control does not work.

10. Troubleshooting

Malfunction
Fluttering/Spitting
spray fan or air bub-
bles appearing in the
suction cup
424 424
All manuals and user guides at all-guides.com
Danger!
Danger!
Steps: [11-1], [11-2], [11-3], [11-2], [11-1]
Cause
Fluid tip has not been
properly tightened
Air distribution ring is
damaged or clogged.
Corrective action
Tighten fluid tip [2-1]
with universal spanner
[7-4]
Replace air distribu-
tion ring, as it will be
damaged during disas-
sembly