Tabla de contenido
Idiomas disponibles
Idiomas disponibles
EN
-
It is possible to cascade several devices to be managed together (if they are in the same DMX address)
or separately (if they are in different DMX addresses).
Use an XLR cable to connect the device's DMX IN to the DMX OUT of the DMX controller when the
device is the first element in the chain. Alternatively, connect to the DMX OUT of the preceding element
in the lighting chain of your installation.
You can also supply power from one light to the next in the chain in the same way as shown in the picture
(POWER IN - POWER OUT).
DMX CONTROLLER
To interconnect them, you must use XLR cables with the following configuration:
IMPORTANT: the complete length of cable used to interconnect the devices in a line must not exceed 100
meters. To prevent line interference, it is recommended that an electric terminator consisting of a 120 Ω
resistor be placed at the last element in the chain between pins 2 and 3 of the XLR DMX OUT connector of
the last element.
-
Connect all the elements to the power supply and turn them on to start using them.
GND
POWER IN
~110-240 V AC. 50/60 Hz FUSE: 5 A
POWER CONSUMPTION: 60 W
MODE
SET
DMX IN
DMX OUT
DMX IN
DMX OUT
GND
POWER IN
~110-240 V AC. 50/60 Hz FUSE: 5 A
POWER CONSUMPTION: 60 W
MODE
SET
DMX IN
DMX OUT
DMX IN
DMX OUT
GND
POWER IN
~110-240 V AC. 50/60 Hz FUSE: 5 A
POWER CONSUMPTION: 60 W
MODE
SET
DMX IN
DMX OUT
DMX IN
1
Ground
Male XLR (pin view)
2
Signal +
3
Signal -
- 4 -
BAR-73L
LED BAR 24 x 3 W
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION : SHOCK HAZARD - DO NOT OPEN
RISK OF FIRE-REPLACE FUSE AS MARKED
POWER OUT
4 A MAX.
BAR-73L
LED BAR 24 x 3 W
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION : SHOCK HAZARD - DO NOT OPEN
RISK OF FIRE-REPLACE FUSE AS MARKED
POWER OUT
4 A MAX.
BAR-73L
LED BAR 24 x 3 W
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION : SHOCK HAZARD - DO NOT OPEN
RISK OF FIRE-REPLACE FUSE AS MARKED
POWER OUT
4 A MAX.
Tabla de contenido
