Troubleshooting; Warranty - Dometic PJS 1000 Instrucciones De Uso

PJS1000

10 Troubleshooting

Fault
The jump starter does not
work. The button
does not respond.
The vehicle is not jump-
started.

11 Warranty

Refer to the sections below for information about warranty and warranty support in the US, Canada, and all other
regions.
11.1 United States and Canada
LIMITED WARRANTY AVAILABLE AT
DOMETIC.COM/WARRANTY.
IF YOU HAVE QUESTIONS, OR WANT TO OBTAIN A COPY OF THE LIMITED WARRANTY FREE OF CHARGE,
CONTACT:
DOMETIC CORPORATION
CUSTOMER SUPPORT CENTER
2320 INDUSTRIAL PARKWAY
ELKHART, INDIANA 46516
1-800-544-4881
[email protected]
EN
Possible cause
The jump starter is deeply
discharged.
Insulation faults, breaks or
loose connections at the
live cables.
Low voltage protection of
the jump starter
Over current protection of
the jump starter
Short circuit protection of
the jump starter
The battery is significantly
sulfated.
The jump starter is less
than 50 % charged.
The battery clamps are
loose or not connected
correctly.
The battery terminals are
dirty or corroded.
Suggested remedy
➤ Charge the jump starter (see chapter "Charging
the jump starter" on page 15).
➤ Check live cables for insulation faults, breaks or
loose connections.
➤ If you cannot find an error, contact an authorized
service agent.
➤ Charge the jump starter (see chapter "Charging
the jump starter" on page 15) to reactivate it.
➤ Remove the load from the USB or 12 V DC output.
Charge the jump starter (see chapter "Charging
the jump starter" on page 15) to reactivate it.
➤ Remove the load from the USB or 12 V DC output.
Charge the jump starter (see chapter "Charging
the jump starter" on page 15) to reactivate it.
➤ Replace the battery.
➤ Charge the jump starter (see chapter "Charging
the jump starter" on page 15).
➤ Check the connections. Ensure that the battery
clamps are firmly secured and connected cor-
rectly. Reconnect if necessary.
➤ Clean the battery terminals and reconnect the
jump starter.
Troubleshooting
19