Operating The Device Safely - Dometic PJS 1000 Instrucciones De Uso

PJS1000

2.2 Operating the device safely

D
DANGER! Failure to obey these warnings will result in death or serious injury.
Electrocution hazard
• Do not touch exposed cables with your bare hands. This applies especially when
operating the device from the AC power supply.
• To be able to disconnect the device quickly from the AC power supply, the socket
must be close to the device and be easily accessible.
!
CAUTION! Failure to obey these cautions could result in minor or moderate
injury.
Explosion hazard
• Do not operate the device under the following conditions:
– In salty, wet or damp environments
– In the vicinity of corrosive fumes
– In the vicinity of combustible materials
– In areas where there is a risk of gas or dust explosion
• Do not place the jump starter near heat sources (heaters, direct sunlight, gas ovens,
etc.).
• Do not leave the device unattended when in use.
Electrocution hazard
• Before starting the device, ensure that the power supply cable and the plug are dry
and the plug is free from rust or dirt.
• When working on electrical systems, ensure that there is somebody close at hand
who can help in emergencies.
• Lay the cables so that they cannot be damaged by sharp edges, doors or the hood.
Do not lay any cable so that it is heavily kinked. Crushed cables can lead to serious
injury.
• Do not disconnect any cables when the device is still in use.
• Never pull the plug out of the socket by the cable.
Fire hazard
• Do not drop, hit or apply excessive force to the device to avoid damage to external
and internal parts.
• Do not place the jump starter near flammable materials.
Risk of injury
• When positioning the device, ensure that all cables are suitably secured to avoid any
form of trip hazard.
A
NOTICE! Damage hazard
• Ensure that the air inlets and outlets of the device are not covered.
• Ensure a good ventilation.
• Set up the device in a dry location where it is protected against splashing water.
EN
Safety instructions
11