Internal Light - Polar GC889 Manual De Instrucciones

EN
Installation
Note: Not for use in vans or trailers, food
trucks or similar vehicles.
Note: If the unit has not been stored or
moved in an upright position, let it stand
upright for approximately 12 hours before
operation. If in doubt allow to stand.
1. Remove the appliance from the packaging and
remove the protective film from all surfaces.
2. When positioning, please ensure a 15cm gap
is maintained along the sides, back and top
of the appliance to allow sufficient airflow.
NEVER LOCATE NEXT TO OR NEAR A
HEAT SOURCE.
3. To avoid being pushed tight against the wall
accidentally and ensure good ventilation,
2 spaces are supplied for mounting on the rear.
4. If necessary, adjust the screw feet of the
appliance to make it level.
Note: Before using the appliance for the
first time, clean the shelves and interior
with soapy water.
Shelf load (Max.): 10kg
Operation
Control panel
Power switch
4
GC889_ML_A5_v2_20221011.indb 4 GC889_ML_A5_v2_20221011.indb 4
Adjusting the Temperature
1. Press SET button. The set temperature is
2. Press up button
3. Press SET button to exit.

Internal light

Press the
internal light on/off.
Glass heater function
Set the switch to desired setting when necessary.
Manual Defrost
To start/stop manual defrost, press and hold
defrost button
Controller reset
1. When the display shows "Disorder', press
2. Quickly press
3. The display will flash for 3 seconds then restore
Glass heater switch
Refrigerant LED:
During refrigerating, LED is on; When
the set temperature is reached and
constant, LED is off.
Defrost LED:
During defrosting, LED is on; When
defrosting finishes, LED is off.
Up Button
Down Button
Manual defrost button/light button
SET
Set button
displayed.
or down button
change set temperature.
button on the controller to turn the
for 6 seconds.
for 2 seconds until the appliance beeps.
for 6 seconds until the
appliance beeps again.
factory settings.
to
2022/10/11 10:58 2022/10/11 10:58