Child Lock - EQUATION OH-1B Manual De Instrucciones

Editing Programs
MODE
1 - Press
bar corresponds to a period of one hour.
SET
2 - Press
bar is flashing (period from 0h to 1h),
+
3 - Press to define that the device must follow the setpoint
temperature during this period, or
be on standby during this period.
4 - The following bar flashes (period from 1 hour to 2 hours) press
-
or to set this period.
5 - Proceed in the same way for each period of the day
SET
6 - Press
first bar is flashing (period from 0h to 1h),
+
7 - Press or
8 - The following bar is flashing (period from 1 hour to 2 hours) press
+ -
or to set this period.
9 - Proceed in the same way for each period of the day
SET
10 - Press
Timer
The Timer function allows the heater to be put into standby mode after a user-defined time.
1 - From standby mode, press
MODE
2 - Press
3 - Use the + and - keys to adjust the setpoint temperature
4 - Press
5 - Set the number of hours using the
corresponds to one hour)
6 - Confirm with the
7 - The display now shows a number of bars corresponding to the
EN
number of hours left before standby. A bar will be erased every
hour.
While setting the timer, if there is no action within 10 seconds, the device exits the setting cycle.
Press

Child lock

The controls can be locked to prevent unintentional use, especially by children. To do this, simultaneously
+
press the and
than 3 seconds. Proceed in the same way to unlock the controls.
Anti-tilt switch
An anti-tilt switch is located in the device, it automatically cuts off the power in the event of a fall or move-
ment of the device.
Thermal cutoff
A thermal cutoff protection switches off heating automatically in case of severe overheating. In this case,
turn off the device, eliminate the cause of the overheating, and allow it to cool before using again.
98
several times to choose Programming mode. Each
, the display shows "12345" (week program) and the first
-
to define that the device must
16:46
, the display shows "67" (weekend program) and the
12345
-
to set this period.
P
to exit edit mode.
0 3
to turn on the device.
several times to choose the power in Manual mode
M
, the symbol is flashing
+
and
key.
for more than 3 seconds to cancel the timer
-
buttons on the control panel or press the
+
20
°C
6 9 12 15 18 21 24
-
keys (one bar
button on the remote control for more
20
16:46
12345
P
0 3 6 9 12 15 18 21 24
20
16:46
67
P
0 3 6 9 12 15 18 21 24
20
16:46
5
M
0 3 6 9 12 15 18 21 24
°C
16:
P
0 3
°C
°C