Directions For Use; Switching Off The Unit - Alice's Garden FINLAND PC1204HC Manual De Instrucciones

EN

DIRECTIONS FOR USE

IGNITING THE PILOT LIGHT
• Before each use and after installing the gas set point, check all
connections.
• Open the gas supply and prime the regulator (push button or tap).
• Push in the control knob and set it to pilot (PILOT).
• Hold the button
times until the pilot lights up. Hold the switch in the PILOT position
for 30 seconds, then release it, the pilot will remain lit.
• If the pilot does not light up, turn the switch back to OFF and re-
peat the above steps.
• Once the pilot light is lit, push the
pushing it in all the way) and turn it to the HIGH position. If the
sunshade is properly lit, you can now select the power level by
turning the switch between HIGH and LOW.
NOTE : The burner may make a noise when it is first switched on. To eliminate this noise, turn the
control knob to the pilot position. Then turn the knob back to the desired position.
RE-LIGHTING THE UNIT
• Turn the switch to the OFF position.
• Wait at least 5 minutes, let the gas evaporate before relighting the pilot.
• Repeat the lighting procedure.
NOTE : For safety reasons, the switch cannot be turned to the OFF position at one time without
first holding it in the PILOT position.

SWITCHING OFF THE UNIT

• Hold down the switch and turn the knob clockwise to the OFF position.
• Close the gas supply valve and/or the pressure regulator.
• Allow the appliance to cool before storing or covering with a cover.
NOTE : After use, the burner grate may be discoloured, this is normal.
34
N
down and push the ignition button several
N
switch gently (without
OFF
PILOT
HIGH
ALLUMAGE
N
LOW
5/07/2022