READ AND SAVE THESE INSTRUCTIONS
EN
Package Contents:
Bottle Sterilizer and Dryer
Measuring Cup
2 Filters
Instruction Manual
WARNING: Read the ENTIRE instruction manual before use to ensure proper safety
precautions, operation and maintenance of this product� Failure to operate in a safe
and responsible manner could result in damage to the product or personal
property and cause serious injury� This appliance shall not be used by children�
Close supervision is necessary when any appliance is used near children� Do not
attempt disassembly� A copy of these instructions is also available online at
drbrowns.co/intl
IMPORTANT SAFEGUARDS
WHEN USING ELECTRICAL APPLIANCES, PRECAUTIONS SHOULD ALWAYS BE
FOLLOWED TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK AND INJURY TO
PERSONS, INCLUDING THE FOLLOWING:
• Ensure that the wall outlet voltage matches the voltage of the appliance�
• Do not operate appliance after it malfunctions or has been damaged in any
manner� Return appliance to the nearest authorized service facility for examination,
repair or adjustment�
• If the supply cord or plug is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified person in order to avoid hazard�
• Place appliance on a level, heat-resistant surface�
• Do not place on or near a hot gas or electric burner, or in a heated oven�
• Do not let cord hang over the edge of a table or counter, or touch hot surfaces�
• Do not use an extension cord�
• DO NOT IMMERSE IN WATER�
• HOUSEHOLD USE ONLY� Do not use outdoors�
• Unplug from outlet when not in use and before adding water�
• Do not spill liquid on cord or plug�
• Do not move appliance while in use or when it contains hot liquids�
• To operate, plug cord into wall outlet� To disconnect, press power button, then
remove plug from wall outlet�
• DO NOT open lid or reach over the appliance while in use, as steam will cause
burns and serious injuries.
• DO NOT touch hot surfaces, including lid, tray and lower rack, during or
immediately after use.
• After sterilizing, wait 10 minutes for parts to cool, then open lid carefully
by handle and beware of residual steam�
• DO NOT EXCEED the recommended amount of water�
• If it is necessary to drain water from the base, always POUR AWAY FROM YOU�
• As the unit switches from the sterilization to the drying cycle, it is expected to see a
large initial release of steam as the fan turns on� Keep a safe distance from the unit
while this cycle is in process�
• Unplug from outlet and allow to cool for 60 minutes before cleaning and
descaling the unit or replacing the filter�
• Be careful to avoid spilling or splashing water on yourself when removing contents�
• The heating element surface is subject to residual heat after use�
Specifications:
Nominal voltage:
220-240 VAC, 50-60 Hz, 600 W
1