Technical Specifications - cecotec bolero SQUAD I 2000 Manual De Instrucciones

ENGLISH
you do not have the necessary training and knowledge, as any damage caused by an incorrect
repair will void the warranty.
Specific faults and solutions
Fault Problem
The LED does not There is no electricity.
turn on when the
unit is connected.
The auxiliary power
supply board and the
board connected to the
display malfunction.
The auxiliary power
supply board is
damaged.
The display is damaged.
Some buttons do The display is damaged.
not work, or the LED
display does not
work as usual.
The cooking power High temperature of the
indicator turns on, cooking hob.
but the heating does
not start.
The fan is faulty.
The power supply board
is damaged.
66
Solution A Solution B
Check if the plug is
correctly fixed in the mains
and if the latter works.
Check the connections.
Substitute the power
supply board.
Substitute the display
board.
Substitute the display
board.
The room temperature
may be high. The air inlet or
outlet may be blocked.
Check if the fan operates
as usual.
If not, substitute the fan.
Substitute the power
supply board.
Heating stops The cookware is not
suddenly during suitable.
operation and the
The cookware diameter
display shows a
is too small.
flashing 'u'.
The hob has overheated.
When you try to heat The power supply
both cooking areas, board and the board
the display shows connected to the display
'u'. malfunction.
The display board on the
communication unit is
damaged.
The main board is
damaged.
The fan motor The motor fan is
produces unusual damaged.
noises.
Note
- These instructions are intended for qualified technicians, do not attempt to carry them
out if you do not have the necessary training and knowledge, as any damage caused by an
incorrect repair will void the warranty.
- Do not try to disassemble the unit on your own to avoid hazards and damages to the
induction hob.

7. TECHNICAL SPECIFICATIONS

Product reference: 02501
Product: Bolero Squad I 2000 hob
Cooking areas: 2 areas
Supply voltage: 220-240 V~ 50/ 60 Hz
Installed electric power: 3500 W
Manufactured in China | Designed in Spain
ENGLISH
Use a suitable cookware. The
cookware
detection
circuit is
damaged,
The unit has overheated.
replace
Wait for the hob
the power
temperature to return to
supply
normal.
board.
Press the On/off button to
restart the product.
Check the connections.
Substitute the display
board.
Substitute the power
supply board.
Substitute the fan.
SQUAD I 2000
67