Operation - cecotec bolero SQUAD I 3000 Manual De Instrucciones

To avoid any damage, the bonding layer and the adhesive must be heat resistant.
-
Connection to the mains
Fig. 9
The induction hob must be connected to the mains by a suitably qualified person.
Before connecting the hob to the mains, check that:
Your home wiring system is suitable for the power consumption of the cooking hob.
1
The mains voltage matches the voltage stated on the rating label of the appliance.
2
The power cable sections can withstand the load specified on the product rating label.
3
To connect the induction hob to the mains, do not use adapters, reducers or branching
-
devices, as they may cause overheating or fire.
The power cable should not be in contact with any hot parts and must be positioned so
-
that its temperature does not exceed 75°C at any time.
Warning
Check with an electrician whether your home wiring system is suitable without modifying it.
Any modifications should only be carried out by a qualified electrician. Fig. 9
If the cable is damaged, it must be replaced by the manufacturer, the supplier or similarly
-
qualified personnel in order to avoid a hazard.
If the appliance is connected directly to the mains, a single-pole residual current circuit
-
breaker with a minimum contact separation of 3 mm must be installed.
The person in charge of the installation must ensure that a correct electrical connection
-
has been made and that it complies with safety regulations.
Do not bend or press the cable.
-
Check the cable for damage regularly.
-
Note:
The bottom surface and the power cable of the hob should not be accessible after installation.

4. OPERATION

The induction hob works by electromagnetic vibrations that generate heat directly in the
cookware, rather than indirectly by heating the surface of the glass. Glass heats only because
the frying pan eventually heats it up.
Fig. 10
Cookware
1
Magnetic circuit 2
Glass ceramic hob
3
ENGLISH
BOLERO SQUAD I 3000
61