cecotec bolero SQUAD I 3000 Manual De Instrucciones página 60

ENGLISH
- The hob incorporates a safety switch that allows it to be completely disconnected from
the mains, which has been installed and positioned in accordance with local electrical
rules and regulations.
- The isolating switch must be of an approved model and provide 3 mm contact separation
on all poles (or on all active [phase] conductors if local wiring regulations allow this
variation of requirements).
- If in doubt about the installation, seek advice from local building authorities and regulations.
- Use heat-resistant and easy-to-clean finishes (such as ceramic tiles) on the walls
surrounding the hob.
After installing the hob
The supply cord should not be accessible through the cabinet doors or drawers.
-
Make sure that there is an adequate flow of fresh air from the exterior of the cabinet to
-
the hob base.
If the hob is installed on a drawers or cabinets space, you must install a thermal protection
-
barrier under the hob base.
The user must be able to access the isolating switch easily.
-
Fixing brackets
You must place the unit on a stable and smooth surface (you can use the packaging). Do
-
not apply force to the buttons protruding from the hob.
Secure the hob to the worktop by screwing the four brackets located on the interior part of
-
the hob (as shown in Fig. 7) after the installation.
Set the bracket position to adapt to the thickness of the worktop. Fig. 8
-
Fig. 8
1. Induction hob
2. Bracket
3. Worktop
Warning
Brackets should not, under any circumstance, touch the interior surfaces of the worktop after
installation. Fig. 8
It is recommended that qualified personnel or technicians install the hob. You should not
-
install it on your own.
Do not install the induction hob directly over a dishwasher, a refrigerator, a freezer, a
-
washing machine or a dryer, as moisture could damage the electric system of the hob.
The induction hob must be installed in a manner that ensures the best heat radiation to
-
obtain the best results.
- The wall and the area over the work surface must withstand the heat.
60