Transportation, Storage And Disposal - Husqvarna R 214T Manual De Usuario

Problem
The cutting result is unsatisfacto-
ry
Transportation
• The product is heavy and can cause crush injuries.
Be careful when you load it onto or off a vehicle or
trailer.
• Use an approved trailer for transportation of the
product.
• Make sure that you have knowledge of local
road traffic regulations before transportation of the
product in a trailer or on roads.
To safely attach the product on a trailer for
transport
WARNING:
not sufficient to lock the product during
transport. Attach the product tightly to the
trailer.
Equipment: 2 approved tension belts and 4 wedge
shaped wheel blocks.
1. Apply the parking brake.
2. Attach the tension belts around the frame or rear
wagon.
3. Tighten the tension belts in the direction of the rear
and the front of the trailer to secure the product.
4. Put the wheel blocks in front of and behind the rear
wheels.
To tow the product
The product has a hydrostatic transmission. To prevent
damage to the transmission, tow the product short
distances only and at low speed.
1686 - 002 - 16.12.2021
Cause
The blades are blunt. See
The grass is long or wet. See
The cutting deck is skew.
There is grass blockage in the cutting deck. See
17 .
The tire pressure is different on the right and left sides. See
page 22 .
The product is operated at a too high speed. See
page 15 .
The engine speed is too low. See
The drive belt slips.

Transportation, storage and disposal

The parking brake is
To examine the blades on page 25 .
To get a good cutting result on page 15 .
To get a good cutting result on page 15 .
Disengage the transmission before you tow the product.
To engage and disengage the drive system on
Refer to
page 13 .
Storage
Prepare the product for storage at the end of the
season, and before more than 30 days of storage. If
you keep fuel in the fuel tank for 30 days or more, tacky
particles can cause blockage in the carburetor. This has
a negative effect on the engine function.
To prevent tacky particles during storage, add a
stabilizer. If alkylate gasoline is used, stabilizer is not
necessary. If you use standard gasoline, do not change
to alkylate gasoline. This can cause sensitive rubber
parts to become hard. Add stabilizer to the fuel in the
tank or in the container used for storage. Always use the
mixing ratios given by the manufacturer. Run the engine
for a minimum of 10 minutes after you add the stabilizer
until it flows into the carburetor.
WARNING:
with fuel in the tank in an indoor location or
in locations with bad airflow. Risk of fire if
fuel fumes come near open flames, sparks,
or pilot lights in for example boilers, hot
water tanks and clothes dryers.
WARNING:
other flammable materials from the product
to decrease the risk of fire. Let the product
become cool before you put it in storage.
• Clean the product, see
17 . Repair paint damages to prevent corrosion.
To clean the product on page
Tire pressure on
To get a good cutting result on
Do not keep the product
Remove grass, leaves and
To clean the product on page
29