Precor Experience 800 Serie Guía De Montaje página 9

Complete the assembly
1. Attach both corner covers and secure each with one screw (see Figure 10).
2. Refer to the console Installation Guide (either online or in the console box) for
instructions on how to install the console, including replacing the power harness.
Once you're done, come back to this page and complete the treadmill assembly
from the next step onward.
3. To position the hood, gently flex the bottom edge of the hood around the bracket
at the front of the treadmill.
4. Insert a screw into each of the two side holes. Partially tighten both screws.
All manuals and user guides at all-guides.com
Figure 10
5. Insert a screw into each of the two outer holes and one screw
two inner holes on the front of the hood. Partially tighten all six screws.
6. Attach the access covers onto each upright using four screws
Figure 11).
7. After completing the console assembly, reattach the back cover (see Figure 2).
8. Fully tighten all screws used in the preceding procedures to 23 ft-lbs of torque, in
the following order:
The four screws that secure the side of the upright supports to the treadmill
•
base (see Figure 5).
The two screws that secure the edges of the upright supports to the
•
treadmill base.
The six screws that secure the console to the upright supports.
•
(see
Figure 11
into the
7