Casals MT300EK Manual De Instrucciones página 6

Ocultar thumbs Ver también para MT300EK:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 8
- Make sure that perforation in the paper correspond
with those on the sanding pad
Warning:
The sanding paper must be fitted firmly on sanding
pad and not come to loose.
To remove the sanding sheet (J) grasp one of tips and
pull it off from the sandind apd (H).
Use:
- Before connecting the power cord to the mains
power supply ensure the switch is in the off position.
- Connect the appliance to the mains.
- Turn the appliance on, by using the on/off switch (A)
Electronic speed control (Fig 2)
- The speed of the appliance can be regulated by
using the speed regulator control (B). This function
is very useful, as it makes it possible to adapt the
speed of the appliance to the type of work that needs
to be done.
- If the appliance works continuously at low speed,
working life of the appliance will be reduced
considerably.
Sawing
- Take special care about the accessories, they
may be stored and used and used according to the
manufacturer's instructions.
- Do not use the appliance if the accessories or
consumables attached to it are defective. Replace
them immediately.
- Always check the workpiece before operation and
remove any obstructions such as nails, staples,
screws, string, rags, cloths and other debris.
- Plunge cutting is only allowed in soft materials
such as word or plastic board.
- Apply light and uniform pressure to obtain a
suitable result.
Sanding
- Take special care about the accessories, they
may be stored and used and used according to
the manufacturer's instructions.
- Do not use the appliance if the accessories
or consumables attached to it are defective.
Replace them immediately.
- Apply uniform pressure to obtain a suitable
result.
Scraping
- To scrape select a high speed rate.
- Apply light and uniform pressure to obtain a
suitable result. Excessive pressure may damage
the surface that you scrape.
Once you have finished using the
appliance:
- Stop the appliance by releasing the on/off
switch. (A)
Cleaning
- Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
- Clean the electrical equipment and the mains
connection with a damp cloth and dry. DO NOT
IMMERSE IN WATER OR ANY OTHER LIQUID.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid
or base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
- If the appliance is not in good condition of
Tabla de contenido
loading

Tabla de contenido