Adjusting Depth Of Cut - Makita CS002G Manual De Instrucciones

NOTICE:
Do not pull the switch trigger hard
without pressing in the lock-off button. This can
cause switch breakage.
CAUTION:
The tool starts to brake the cir-
cular saw blade rotation immediately after you
release the switch trigger. Hold the tool firmly to
respond the reaction of the brake when releasing
the switch trigger. Sudden reaction can drop the tool
off your hand and can cause a personal injury.

Adjusting depth of cut

CAUTION:
After adjusting the depth of cut,
always tighten the lever securely.
Loosen the lever and move the base up or down. At the
desired depth of cut, secure the base by tightening the lever.
For cleaner, safer cuts, set cut depth so that no more
than one blade tooth projects below workpiece. Using
proper cut depth helps to reduce potential for danger-
ous KICKBACKS which can cause personal injury.
Fig.4
► 1. Lever 2. Loosen 3. Tighten
Sighting
Place the alignment point of the base on your intended
cutting line on the workpiece.
The sight window in the base makes it easy to check
the distance between the front edge of the circular saw
blade and the workpiece whenever the circular saw
blade is set to the maximum depth of cut.
2
4
3
Fig.5
► 1. Alignment point 2. Cutting line 3. Base 4. Sight
window 5. Front edge of the circular saw blade
1
2
3
2
1
5
8 ENGLISH
Lighting the lamp
CAUTION:
Do not look in the light or see the
source of light directly.
To turn on the lamp without running the tool, pull the
switch trigger without pressing the lock-off button.
To turn on the lamp with the tool running, press and hold
the lock-off button and pull the switch trigger.
The lamp goes out 10 seconds after releasing the
switch trigger.
Fig.6
► 1. Lamp
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
Dust case
CAUTION: Do not touch metal chips and the
dust case with bare hands immediately after the
operation. They may be extremely hot and could
burn your skin.
CAUTION:
Do not cut the material on which
thinner, gasoline, grease, or other chemicals are
applied. The metal chips of such materials can dam-
age the dust case and result in breakage which can
cause personal injury.
CAUTION:
Wear eye protection or goggle
when emptying the dust case.
Metal chips are collected into the dust case. Periodically
dump the metal chips before the metal chips become
visible through the sight window.
Fig.7
► 1. Sight window 2. Dust case
1
2
1