FONESTAR ZS-2000M Manual De Instrucciones página 3

FAULT CONFIRMATION
When the system detects a fault, a failure warning tone is heard.
Press the FAULT button to confirm the fault. The warning tone stops, and the fault indicator light turns orange.
EQUIPMENT STATE RESTORATION
When the system fault has been identified and fixed, the equipment state needs to be restored.
Press the RESET button to reset the equipment state. All fault indicator lights are restored to their normal
states, and the fault warning tone stops.
SYSTEM SELF-TEST
The ZS-2000M self-test function is activated by pressing the TEST button on the front panel.
Operation steps involve the following:
1. Press the TEST button to activate the self-test function for the ZS-2000M and equipment connected to
the system.
All of the indicator lights that display just one color are turned on. All of the lights that can display two
colors switch back and forth between these two colors. The fault indication buzzer rings continuously.
2. Press the TEST button again to stop the self-test program.
Nota: The self-test function does not affect the normal operation of other functions unrelated to the
self-test function. For example, if the self-test function is initiated during voice broadcasting,
the voice broadcast function is not interrupted and the all indicator lights will flicker.
The system times out in one minute by default. If the self-test function occurs for a minute
without being manually halted, the system automatically stops the self-test function.
ZONE SELECTION
A zone is selected by pressing the button that represents the zone. Press the selected zone button again to
deselect the zone.
Press the ALL button on the ZS-2000M front panel to select all zones, and press this button again to des-
elect them.
Note: Only the enabled zones which have been set in the config software are selectable.
Zone state indicator lights have the following meanings:
- A solid orange light indicates the zone has been disabled or has short-circuited.
- A flickering orange light indicates the zone has an open circuit.
- Green light indicates that the system is broadcasting.
- Red light indicates the system is broadcasting fire emergency information.
- A flickering green light indicates the zone has been selected. When the light is off this indicates the zone
is either not selected or is not in use.
- If a zone is selected and no other operation is performed for more than one minute, the zone indicator
light automatically returns to its original state.
ZONE MONITORING
The ZS-2000M can monitor sound being broadcast in certain zones. Perform the following steps to monitor
sound being broadcast in particular zones:
1. Press and hold to the MONITOR button until the following step 2 has finished.
2. Select the needed zone to be monitored. The monitoring loudspeaker plays the sound being broadcast
in the selected zone.
The ZS-2000M can only monitor one zone, and the system automatically cancels the previous zone that
has been selected if another zone is selected. Repeat the above operations can monitor the other zones.
3. Press the MONITOR button again to stop zone monitoring.
- 3 -
EN