Powerfix Profi PFRS 1.5 A2 Instrucciones De Uso página 23

Melting and filling (Figs. C + D)
♦ Place the On/Off switch
"ON" to switch the appliance on.
♦ Press and hold the activation button
heat up the wax melter tip
♦ Now melt small portions of the hard wax and
place them into the damaged area, until it is
slightly overfilled. Start with the light colour
tones and progress step by step to the dark
colour tones.
Filling (Fig. E)
♦ For vertical surfaces it is recommended to mix
the colour tone beforehand, collect it on the
scraper
When working on curved areas the scraper
with curvature
wax into the damaged area.
Smoothing (Fig. F)
♦ Allow the hard wax to cool for a few seconds
(about 10 seconds).
♦ After cooling, smooth any protrusion with the
planing grooves of the scraper
light pressure to smooth the protrusion.
Fine matching (Fig. G)
♦ For fine matching, now imitate any marbling
with a darker colour tone.
♦ Subsequently, again smooth any protrusion
with the planing grooves of the scraper
Degreasing (Fig. H)
♦ To finish, remove the last hard wax residues
with the sanding sponge
gloss level of the surface will also be simulta-
neously matched. Job done!
Cleaning the planer grooves (Fig. I)
♦ Place the cleaning scraper
wax melter tip
dues from the plane grooves.
│ GB │ IE
■ 20
and then fill the damaged area.
should be used to fill hard
and scrape the wax resi-
at the position
to
.
. Use only
. Thereby the
on the cooled
PFRS 1.5 A2
.