4.5. Out-Of-Balance Detection System; Requirements - Milnor MilTouch MWF27Z8 Serie Guía Del Operario

BICLUT04 (Published) Book specs- Dates: 20170804 / 20170804 / 20170804 Lang: ENG01 Applic: CLJ

4.5. Out-of-Balance Detection System

The MilTouch controller on some machine models includes software to help protect the washer-
extractor from potential damage caused by imbalanced loads.

Requirements

4.5.1.
These elements are necessary for the out-of-balance detection system to work properly:
• MilTouch software build V028 or later
To verify the MilTouch software build, touch the Milnor logo in the upper left corner of the
Tip:
home screen (see
the side of the controller. The build number is written on the card (see
Figure 37: MilTouch Home Screen
.
Figure 37). If the home screen is not available, remove the SD card from
Screen Capture
53
Chapter 4. Troubleshooting
Figure 38).
Legend
A. Touch here for software
build number
B. Touch here for diagnostics
screens
PELLERIN MILNOR CORPORATION