Milnor MilTouch MWF27Z8 Serie Guía Del Operario página 38

Chapter 3. MilTouch
speed with the drain open, the cylinder accelerates to RinSave
available only on machines with RinSave
standard drain speed on other machines.
The RinSave drain type is valid only when followed immediately by a bath step. If a RinSave
Tip:
operation is programmed before an extract step, the controller will substitute a standard drain
operation when the formula runs.
Note 3: For most models, the controller monitors the vibration switch or excursion microprocessor input
(model dependent) during RinSave operations. If the input indicates too much vibration or excursion, the
controller cancels the remaining drain time, commands a RinSave coast, then starts the next bath step. For
divided cylinder models and Staph Guard models, the 3-wire circuit opens to stop the machine.
Re-Use Drain (Optional)
3.1.15.
To Sewer—Drain this bath to the sewer.
To Reuse—If machine is equipped with an optional second drain, this selection allows draining
this bath to an optional reuse tank.
How to End Formula
3.1.16.
How should this formula end?
Stop—Stop and require operator to cancel the signal
Reversing—Reversing at wash speed and require operator to end formula
Rotating—Rotating at wash speed and require the operator to end the formula
Tumble—Tumble at wash speed for two minutes, then sound signal
Stop + Signal—Stop and sound operator signal for two minutes, then shut off.
Reversing + Signal—Reverse at wash speed with signal sounding for two minutes, then shut off.
Rotating + Signal—Rotate at drain speed for two minutes with signal, then shut off.
Tumble + Signal—Tumble for two minutes, then tumble with signal for two minutes, then shut
off.
PELLERIN MILNOR CORPORATION
™ Wash Formulas
— End of BICLJP02 —
34
®
speed. This drain action is
®
software; this drain action is replaced by the