Tabla de contenido
Idiomas disponibles
Idiomas disponibles
PSS 3100 SE
Material
Plastic material (styrofoam)
Plastic material (styrofoam)
Hardwood, softwood, laminated wood, wood-fiber insulation material
Hardwood, softwood, laminated wood, coated panel material
Hardwood, softwood, laminated wood, coated panel material, fiber cement
board
Hardwood, softwood, laminated wood, overlaid panel materials, fiber-cement
panels, soft fiber
5.4 Setting the feed speed
The feed speed can be continuously adjusted between 4 and 20 m/min [13.12 - 65.62 ft/min].
Use the following procedure to adjust the feed
speed:
1.
Set the desired feed speed with the rotary
switch 1.
Turning the rotary switch counterclockwise
➢
turns the feed off.
✓
The feed speed is set.
A diagram attached to the control panel shows suitable "material – saw blade – feed speed"
combinations.
Use it for reference when setting the feed speed.
5.5 Switching off
Use the following procedure to switch off the
machine:
1.
Release the rocker switch 3.
➢
Feed and saw blade drive are switched off
immediately.
The saw blade comes to a standstill in less
➢
than 10 seconds.
✓
The machine is switched off.
01/2022
Fig. 11: Setting the feed speed
Fig. 12: Switching the machine off
Step
Rotational speed
rpm
1
2600
2
3150
3
3700
4
4200
5
4650
6
5200
21
Tabla de contenido
