Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3.6 Residual risks
The existing residual risks include:
- Touching the saw blade that extends below the guide rail when the unit starts to cut.
- Touching the saw blade during and after cutting if the stop slide is not correctly set to automatically return
the unit in its home position.
- The machine might tip over if the far end of the guide rail is not properly supported when it extends beyond
the workpiece to be cut.
- Contact with the part of the saw blade that protrudes below the workpiece during the cutting process.
- Contact with rotating parts from the side: Saw blade, clamping flange and flange bolt.
- Breakage and ejection of the saw blade or parts of the saw blade.
- Impaired hearing when working without hearing protection for long periods of time.
- Emission of harmful wood dusts during longer operation without extraction.
4
Setup / adjustment
4.1 Mains connection
Prior to starting up the machine, check to ensure that the mains voltage corresponds to the operating voltage
specified on the rating plate of the machine.
4.2 Routing of the connecting cable
14
Warning
Risk of injury when working with the machine
Even when the machine is used as intended and in compliance with the safety
regulations, there are still residual risks caused by the intended use, which can
have consequences for your health.
➢
Observe the safety instructions and information in these instructions.
Always be extremely careful and cautious when you work with the machine.
➢
Warning
Electric shock when cutting into the connecting cable
The connecting cable can impair safety functions and work functions and
get into contact with the cutting tool. Cutting into the connecting cable of
the machine puts the metal parts of the machine under tension and causes
an electric shock. There is a risk of injury for the user.
When working, pay attention to the way the connecting cable is
➢
routed.
Never cut into the connecting cable of your machine.
➢
PSS 3100 SE
01/2022
Tabla de contenido
