Overheat Protection; Switch Action - Makita DUC101 Manual De Instrucciones

Overheat protection

When the tool or battery is overheated, the tool stops
automatically. In this case, let the tool and battery cool
before turning the tool on again.
Overdischarge protection
When the battery capacity is not enough, the tool stops
automatically. In this case, remove the battery from the
tool and charge the battery.

Switch action

WARNING:
For your safety, this tool is
equipped with lock-off lever which prevents the
tool from unintended starting. NEVER use the tool
if it runs when you simply pull the switch trigger
without pressing the lock-off lever. Return the
tool to our authorized service center for proper
repairs BEFORE further usage.
WARNING:
NEVER tape down or defeat pur-
pose and function of lock-off lever.
CAUTION:
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
NOTICE:
Do not pull the switch trigger hard with-
out pressing the lock-off lever. This can cause
switch breakage.
To prevent the switch trigger from being accidentally
pulled, a lock-off lever is provided. To start the tool,
depress the lock-off lever and pull the switch trigger.
Release the switch trigger to stop.
1
Fig.5
► 1. Switch trigger 2. Lock-off lever
Checking the run-down brake
CAUTION:
If the saw chain does not stop
within a few seconds in this test, stop using the
tool and consult our authorized service center.
Run the tool, and then release the switch trigger com-
pletely. The saw chain must come to a standstill within a few seconds.
ASSEMBLY
CAUTION:
switched off and the battery cartridge is removed
before carrying out any work on the tool.
CAUTION:
hands. Always wear gloves when handling the saw chain.
Removing or installing saw chain
CAUTION:
still hot just after the operation. Let them cool down
enough before carrying out any work on the tool.
CAUTION:
ing or removing saw chain in a clean place free from sawdust and the like.
Removing the saw chain
To remove the saw chain, perform the following steps:
1. Pull the lever up.
2
Fig.6
► 1. Lever
2.
Turn the lever counterclockwise until the sprocket
cover comes off.
Fig.7
► 1. Sprocket cover 2. Lever
9 ENGLISH
Always be sure that the tool is
Do not touch the saw chain with bare
The saw chain and the guide bar are
Carry out the procedure of install-
1
2
1