Steinberg Systems SBS-MD-20 Manual De Instrucciones página 31

CAUTION!
mark the location where the item will be placed to make it easier to find later. Do
not place a valuable item in tall grass or bushes.
6. Holding the probe parallel to the ground, about 1-5 cm above the surface,
move it slowly over the area where the sample is placed.
Make the movement from side to side.
MOVING THE DETECTOR'S PROBE
1. When searching, it is best to move the detector from side to side,
approximately 1 - 5 cm above the surface being searched.
The probe should be guided along an arc with a radius of 7-8 cm, parallel to
the ground.
CAUTION!
cause false readings of the detector.
2. The movement should be slow and at a constant speed.
3. When a target under the ground surface is found and identified, the detector
will emit a single beep and the target found icon will flash. The LCD display will
also show the reading value and the depth at which the target was detected.
4. If the detector does not detect any object, make sure that the operating mode
is set correctly and that the probe is moved correctly.
5. The detector responds with a signal when it detects valuable metal objects. If
the signal does not repeat after moving the probe over the target several
times, it is probably scrap metal.
If a valuable metal such as gold will be used to test the detector,
The probe movement should not resemble a pendulum. This may