Tabla de contenido
Idiomas disponibles
Idiomas disponibles
THINK SAFETY
SAFETY IS A COMBINATION OF OPERATOR COMMON SENSE AND ALERTNESS AT ALL
TIMES WHEN THE DRILL PRESS IS BEING USED.
WARNING
second is sufficient to inflict severe injury.
LASER SAFETY
WARNING
Do not stare directly at the laser beam. Eye damage may occur if you deliberately stare into the beam.
The laser light beam used in this system is Class II with maximum 1 mW and 640 nm
wavelengths. AVOID DIRECT EYE EXPOSURE.
The laser must be used and maintained in accordance with the manufacturer's instructions:
Never aim the beam at any person or an object other than the workpiece.
Do not project the laser beam into the eyes of others.
Always ensure the laser beam is aimed at a workpiece without reflective surfaces as the laser
beam could be projected into your eyes or the eyes of others.
CAUTION
ELECTRICAL REQUIREMENTS
Connection to a Power Source
This machine must be grounded while in use to protect the operator from electric shock.
Plug power cord into a 110-120V properly grounded type outlet protected by a 15-amp dual
element time delay fuse or circuit breaker.
Not all outlets are properly grounded. If you are not sure that your outlet, as pictured in Figure 1,
is properly grounded; have it checked by a qualified electrician.
DANGER
DANGER
electrocution or serious shock, particularly when
used near metal plumbing or other metal objects.
If shocked, your reaction could cause your hands
to hit the tool.
WARNING
replaced immediately to avoid shock or fire
hazard.
Your unit is for use on 120 volts. It has a plug that
looks like the one in the Figure 1.
This power tool is equipped with a 3-conductor cord and grounding type plug, approved by
Underwriters Laboratories and the Canadian Standards Association. The ground conductor
has a green jacket and is attached to the tool housing at one end and to the ground prong in
the attachment plug at the other end.
If the outlet you are planning to use for this power tool is of the two-prong type, DO NOT
REMOVE OR ALTER THE GROUNDING PRONG IN ANY MANNER. Have a qualified
electrician replace the TWO-prong outlet with a properly grounded THREE-prong outlet.
Do not allow familiarity (gained from frequent use of your drill press) to
become commonplace. Always remember that a careless fraction of a
To reduce the risk of injury:
Use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous laser radiation exposure.
To avoid electric shock, do not touch the metal prongs on the plug when
installing or removing the plug to or from the outlet.
Failure to properly ground this
power tool can cause
If power cord is worn, cut or
damaged in any way, have it
Fig . 1
7
Tabla de contenido
Solución de problemas
