Person Present Operation; Radio Receiver - CAB SHADE Manual De Instrucciones

WIND sensor:
Having exceeded the threshold set on the trimmer, the control unit goes into "wind alarm" (notified by a rapid flashing
of the red LED) and commands the closure of the motor.
The "wind alarm" time having ended, depending on the configuration (see DIP2), it returns to the previous condition
or remains closed.
During the "wind alarm" period, the unit excludes any other command.
The "wind alarm" duration is of 8 minutes, but for the first 10 minutes from switching on, the unit works with the
alarm period reduced to 20 seconds to enable the testing of the operability in an unhindered manner.
SUN sensor:
When the light threshold is exceeded (set through the trimmer) for 8 minutes, the unit commands the opening of the
motor. The reverse process is applied when the light drops below the threshold set, after 8 minutes (20 seconds if
within 10 minutes of switching on) the control unit commands the closure of the motor.
The "sun alarm" duration is of 8 minutes, but for the first 10 minutes from turning on, the unit works with the alarm
period reduced to 20 seconds to enable the testing of the operability in an unhindered manner.
RAIN sensor:
When the rain sensor activates, the unit goes into "rain alarm" (notified by a slow flashing red LED) and commands
the closure or opening of the motor (depending on the setting of DIP4)
During the "rain alarm" period, the unit excludes any other command.
The "rain alarm" duration is of 8 minutes, but for the first 10 minutes from switching on, the unit works with the
alarm period reduced to 20 seconds to enable the testing of the operability in an effortless manner.

PERSON PRESENT OPERATION

By placing all the Dip switches to the ON position, the control unit is configured to the PERSON PRESENT mode:
- Only the inputs on the OP/CL terminal block operate, the radio commands and the rain/wind/sun inputs have no effect
- the pressure on the OPEN/CLOSE buttons or Step by Step switches must be maintained for the whole duration of
the manoeuvre.
MEMORISING OPERATION TIME
The operation time is set by default at 120 seconds, but you are advised to set the correct operation time as follows:
Set all the dip switches to ON (Person Present)
- From the closure position, press OPEN and keep it pressed until the desired level of opening has been reached
- Then press CLOSE and keep it closed until the desired level of closure has been reached
- Reposition the DIP as required
The time is memorised with an addition of a 5 second margin compared with the effective opening and closure time calculated.

RADIO RECEIVER

Up to a maximum of 14 transmitters can be memorised (notification is given of a full memory; when memorising a
further transmitter is attempted, the LED flashes 8 times)
The first memorised radio command also sets the type of coding accepted:
- If with Fixed Code, the code Fix + HCS is accepted
- If HCS only the HCS code is accepted
- If ARC only the ARC code is accepted
14