Supported Sensors; Connect To The Nmea 2000® Network - Veratron LINK UP Serie Manual De Instrucciones

SUPPORTED SENSORS

o Fuel Level
o Freshwater Level
o Wastewater Level
o Trim Level
o Rudder Angle
o Coolant Temperature
CONNECT TO THE NMEA 2000® NETWORK
Once the sensor installation is complete you can interface the
Link Up gateway to the NMEA 2000® backbone through the
dedicated plug.
Please ensure to tighten the M12 connector by screwing it onto
its counterpart, so to preserve the water tightness.
A drop cable is not needed unless the total length of the Link Up
device is not enough to reach the NMEA 2000® backbone. In
this case it is possible to extend the total length by using one of
the accessory drop cables.
Please note that NMEA 2000® does not allow drop cables
longer than 6 meters.
Refer to the NMEA 2000® standard for a proper network
design.
If power from the NMEA 2000® network is received, the green
LED on the Link Up housing will start flashing (see "LED
notifications").
SYSTEM INSTALLATION
o Boost Pressure
o Oil Temperature
o Oil Pressure
o Gear Oil Pressure
o Gear Oil Temperature
o Trim Tabs
B000647