System Installation; Before The Assembly; Connect The Sensor - Veratron LINK UP Serie Manual De Instrucciones

SYSTEM INSTALLATION

BEFORE THE ASSEMBLY

1. Before beginning, turn off the ignition and remove the ignition key. If necessary, remove the main
circuit switch.
2. Disconnect the negative terminal on the battery. Make sure the battery cannot unintentionally
restart. Short circuits can cause fires, battery explosions and damages to other electronic systems.
3. Install the device at least 50cm away from any magnetic compass.
4. The Link Up must be mounted and handled in an ESD protected area.
5. The device may not be damaged.

CONNECT THE SENSOR

Depending on the sensor to be configured, connect the Link Up plug to the sensor according to the
following pin assignment.
If the sensor is not equipped with the matching connector, it is possible to either crimp a male counterpart
on it (see "Technical Data"), or simply cut-off the sensor plug on the Link Up and manually connect the wires.
Veratron level sensors are already designed with the matching AMP connector for a plug-and-play
installation.
The contacts must audibly lock into place.
A. TE AMP SuperSeal 1.5 series female plug
B. Blue wire – Sensor input
C. Black wire – Sensor ground
SYSTEM INSTALLATION
B000647