Maxon 250477 Instrucciones página 3

LIFT CORPORATION Sht. 3 of 10 DSG#
3. Align hole in decal (FIG. 3-1)
with the 10 mm hole for mounting
the switch. Attach decal to panel as
shown in FIG. 3-1.
NOTE: The 3-conductor cable contains
a black wire. Do not use the
black wire. Ensure cut end of
black wire is sealed and taped
to 3-conductor cable.
4. In the vehicle cab, crimp ring terminals (14-
16 AWG, Kit items) to the green wire and
white wire on the 3-conductor cable (Kit
item) (FIG. 3-2). Then, attach the green
wire and white wire to the terminals on the
in-cab switch (FIG. 3-2).
5. To attach the switch to vehicle cab, turn
the knob and hex nut counter-clockwise
to remove from switch (FIG. 3-3).
Insert switch bushing through 10 mm
hole in panel. Turn pal nut to adjust the
distance the bushing protrudes from
panel. Reinstall hex nut to attach switch
to panel. Then, reinstall knob.
© MAXON Lift Corp. 2017
M-88-38
Rev. B Date: 06/21/17
10 MM HOLE
FOR SWITCH
ATTACHING SWITCH DECAL
FIG. 3-1
GREEN WIRE
14-16 AWG
RING TERMINALS
(2 PLACES)
CRIMPING IN-CAB SWITCH
WIRING TO TERMINALS
FIG. 3-2
BUSHING
KNOB
HEX NUT
ATTACHING SWITCH TO PANEL
FIG. 3-3
WHITE WIRE
DECAL
PAL NUT