Motion BLINDS CM-40 Manual página 26

3 Connect power supply
Only connect CM-21 (12VDC transformer) or
CM-38/CM-39 (rechargeable battery tube)
If your blind has been programmed you do not have to initialize your motor. Shortly pull the cord to see if the blind moves,
If the blind does not move the blind has to be initialized. Read steps 4.1 - 4.5 before pressing the program button on the
motor. The motor will automatically start the programming sequence.
4 Initialize the motor
8
M OTI O N C M- 40 D C VE RTICAL M OT O R
Short
press
Warning : Make sure the slats move towards your packside. Shortly
4.1
press the program button on the motor. The blind will start the
programming sequence and the slats will start moving. If the slats
move the opposite direction, shortly press the program button again.
The blind will stop moving. Shortly press the program button again to
move the slats in the opposite direction. Once the slats have reached
the end position, this position will be saved automatically, confirmed
by a single beep.