Maintenance; Warranty; General Warranty Requirements; Disposal - Delta DC Wallbox Charger Manual De Instalación Y Operación

Maintenance

Annual Requirements
1. Replace the ventilation filter.
2. Conduct a visual inspection of the charging cable and ensure that cable does not show any
visual damage or deformation.
3. Conduct a visual inspection of the charging gun and ensure that gun does not show any visual
damage, arcing or rust.
WARNING!
!
To avoid danger of electrical shock or injury, turn off power at the panel board or load center
before working on the equipment or removing any component. Do not remove circuit
protective devices or any other component until the power is turned off.
Disconnect electrical power to the DC Wallbox before any maintenance work to ensure that it is
separated from the supply of AC mains. Failure to do so may cause physical injury or damage to
the electrical system and charging unit.
Note:
Before switching off the main breaker to cut off power, please record the error code on

the display screen.
Even when the key switch is turned off, the circuit before the main terminal is still

hazardous. Please only operate visual inspection at this moment.
Maintenance of the DC Wallbox shall be conducted only by a qualified technician.

Note:
After opening the front door, turn off the main breaker and auxiliary breaker before any

maintenance work.

Warranty

General warranty requirements

Delta warrants that the products will be free from defects in materials and workmanship for a period of
two years for EVSE from the S/N stamped on the product by the original purchaser from Delta Com-
pany. This warranty only applies to the original purchaser and is not transferable to a third party.

Disposal

After correctly decommissioning the device, please have it disposed by the service department in com-
pliance with current waste disposal regulations. Electrical and electronic devices including accessories
must be disposed of separately from general waste.
Recycle any packaging material that are of recyclable material such as paper, carton,
wood, etc., and throw other non-recyclable packaging material in the trash bin. You
can make a significant contribution to protecting our environment by reusing or recy-
cling the material.
Installation and Operation Manual 22
Maintenance