Technical Specifications - Fermax DUOX PLUS 10S Guía Inicio Rápida

Ocultar thumbs Ver también para DUOX PLUS 10S:

Guía inicio rápida (9 páginas)

Contenido

página de 17

/ 17
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

FEATURES

INCREASE THE DISTANCE

Increased terminal distance to each of the 10 outputs, up to 3 terminals on one output.

PROGRAMMING

Programming of home terminals: To select the programming mode we must configure the dipswitches

of the decoder. Make sure that the DL LED shows that the programming has been completed and

remains fixed.

Sequential mode:

With the decoder powered and the LED on, Press the PGM button for more than 1 second and less

than 10 seconds. When the button is released, the decoder starts, for each of the 10 outputs, the

terminal programming.

The address assigned to each of the outputs depends on the dipswitches configuration. See

ADDRESSES TABLE

Direct mode:

free programming of terminals.

With the decoder powered up and the LED lit, set minidip number 8 of the "DECODER" dipswitch to

ON (Direct mode), minidip 8 of the "BLOCK" dipswitch to ON.

There are two ways of programming an output:

- If the terminal has a programmed address already; by sending an F1 command, auto-on or Guard

unit call (key), the decoder will pick up the terminal address and store it in the output that has

received the command.

- If the terminal does not have an address, we can carry out the inverse programming with the panel.

Once we have finished the programming, put the dip 8 of the dipswitch BLOCK to OFF.

BLOCK THE INSTALLER MENU:

To avoid possible errors or misuse by the user, the access to the installer menu on the monitor can be

controlled by the decoder.

Sequential mode:

- To block the installer menu: After programming the decoder outputs, the installer menu will be

blocked.

- To unblock the installer menu: Press the programming button (PGM) on the decoder for 10

consecutive seconds to access the installer menu from the monitor. After 30 minutes it will be

locked again.

Direct mode:

- To block the installer menu: Minidip 8 of dipswitch "BLOCK" to OFF.

- To unblock the installer menu: Minidip 8 of dipswitch "BLOCK" to ON.

ISOLATION BETWEEN TERMINALS

If a short circuit, voltage lower than 15 Vdc or over consumption (peak consumption greater than

2 A) is detected in any of the 10 outputs, this will be isolated from the rest.

Every decoder output has 1 red LED, if it is on, it indicates that the output has a problem. We can

disconnect the output or turn off the decoder to recover it. If the short-circuit occurs in the cable without

having a terminal connected or there is a telephone connected, once the short-circuit is eliminated, the

output recovers automatically.