Blaupunkt VIO-B40 Guia De Inicio Rapido página 8

Step 5:
• Move the Ethernet Network Port Cable and Camera Power Connector Cable through
the (wall or ceiling).
Step 6:
• Use the 3 plastic anchors and insert them
into the 3 holes you just drilled.
Step 7:
• Take out the installation screws. Tighten
the screws to fix the device onto the
installation surface. You can move the
device sunshade back and forth to avoid
direct (sun) light impact.
Step 8:
• Connect the Camera Power connector to the included power supply cable. Then
connect the power supply cable to the power line socket. Optional: If you want to
install your camera via Ethernet cable, connect your camera to the router using an
Ethernet cable.
Step 9:
• Use the cross screwdriver to loosen the "Adjusting Screw".
Step 10:
• Adjust the device in all possible directions, and set it to the desired monitoring area.
Step 11:
• Adjust the device in all possible directions, and set it to the desired monitoring area.
8
1
1. Sunshade
2. Adjusting Screw
2