1.
Slide the cover open in the direction indicated by the
arrow.
2.
Insert the batteries (AAA, LR03, 1,5 V - not provided)
into the remote control and make sure the poles match.
3.
Put the cover back on.
4.
Point the remote control towards the receiver on the air
conditioner.
5.
The remote control should be positioned within 6
metres from the receiver.
6.
There must be no obstacles between the remote
control and the receiver.
7.
Do not drop or launch the remote control.
8.
Do not leave the remote control under strong sunlight
or heating devices and other source of heat.
9.
Remove the batteries from the remote control when the
latter is not used for a long time.
10. If no sound is heard and the transmission symbol on
the display does not flash, the batteries must be
replaced.
11. If the system resets when the remote control button is
pressed, the electrical signal is poor and the batteries
must be replaced.
12. Flat batteries must be disposed of correctly.
N.B.:
* The image depicts a general remote control, which contains
nearly all the function keys. These may be of a slightly different
material (depending on the model).
INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EUROPEAN DIRECTIVE
2006/66/EC and amendments Directive 2013/56/EC
Please replace the battery when its electrical charge has been exhausted: at the end of its useful life, it must not be disposed of
together with unsorted waste. It must be must be delivered to appropriate separated waste disposal plants or to dealers that
provide a similar service. Separate waste disposal of batteries prevents potential negative effects on the environment and human
health resulting from inadequate disposal, and also allows the materials from which it is made to be recovered and recycled in
order to achieve significant savings in terms of energy and resources. The separate disposal obligation is underlined by the
crossed-out dustbin symbol appearing on the battery. Illegal disposal of the product by the user shall result in the application of
administrative sanctions as defined by current regulations.
THE TANK MUST BE FILLED WITH DEMINERALIZED WATER FOR THE APPLIANCE TO
OPERATE IN COOLER/HUMIDIFIER MODE.
The water is inserted directly into the rear tank. Before introducing the water, check that there are no water residues inside
the water pump, to prevent its leakage.
Fill the tank up to the maximum level marked on the water indicator, without exceeding the water level limit, this could
cause water leakage.
When using the appliance for first time, remove the cardboard support positioned inside the tank.
V 12/20
REMOTE CONTROL OPERATION
FILLING THE WATER TANK
19