Connecting The Composite Video Signal To The Monitor - GE UltraView LCD 17 in Manual De Usuario

EN • 12 UltraView LCD 17 in./19 in. Monitor
Figure 5: Location of the power adaptor socket on the rear of the monitor
Power adaptor socket
Then connect the power cord to the adaptor. Adjust the viewing angle of the monitor
to fit the required viewing requirements.

Connecting the composite video signal to the monitor

The monitor has two sets of BNC connectors located on the side of the monitor for
composite video input/outputs (see Figure 3 on page 9). All video inputs are passive
loop-through when operating in a single connection mode. If a cable is also
connected to the output connector, the video signal can be passed on to another
monitor connected to it via the passive loop-through function.
Figure 6: Connecting the monitor to a video camera
Connecting a
single monitor
to a video
camera
Connecting
multiple
monitors to a
video camera
Press the Mode button (see Figure 1 on page 7) to select the video source
(Composite 1/2).