Eldom ribby HO110C Manual De Instrucciones página 13

GENERAL DESCRIPTION
1. Thermostat
2. Supply switch
3. Indicator light power
4. Handle
5. Ventilation openings
6. Heating fins
7. Castors
TECHNICAL DETAILS
Rated power: 2500 W
Mains supply: 220-240 V ~ 50-60 Hz
INTENDED USE
The HO110C oil heater is intended for heating residential premises. It has been produced to the highest
requirements and use of advanced technology. Due to the manufacture pursuant to high standards, it is safe
and easy in use.
USING THE DEVICE
• After unpacking the device, make sure if it was not damaged during the transport. In case of any doubts,
refrain from its use until contacting a service point.
• Install the feet with castors (6) - pic. 2.
• Place the unit on a flat, stable and heat-resistant floor, min. 2 m away from furniture and flammable objects.
• Set the thermostat (1) in the "LOW" position.
• Connect the device to the power supply source of the parameters compliant with those stated in the user
guide.
• Using the switch (2) select the heating power:
- "I" for 1000 W
- "II" for 1500 W
- "III" for 2500 W
• The device will start when temperature is selected with the thermostat knob (1). The maximum operating
temperature is set when the thermostat button (1) is set to "HIGH" and the heating level "III" is selected.
• Operation of the device is signalled with the indicating lamp (3).
The device is operating only whe set vertically. It has a safeguard cutting off the power supply when it
is overturned.
• During operation of the device, do not cover the heater with clothing or other textiles.
• Do not cover ventilation openings.
• The device has a thermal safeguard cutting off the power supply when it is overheated. In this case, set the
thermostat knob in the "LOW" position, disconnect the device from the power supply and eliminate the cause
of overheating. Leave the device to cool down before switching the device on again.
OPERATING INSTRUCTION
OIL FILLED RADIATOR HO110C
1
2
3
4
5
PIC. 1
EN
7
6
13