Steinberg Systems SBS-MD-22 Manual De Instrucciones página 29

2. The movement should be slow and at a constant speed.
3. When a target under the ground surface is found and identified, the detector
will emit a single beep and the target found icon will flash. The LCD display will
also show the reading value and the depth at which the target was detected.
4. If the detector does not detect any object, make sure that the operating mode
is set correctly and that the probe is moved correctly.
5. The detector responds with a signal when it detects valuable metal objects. If
the signal does not repeat after moving the probe over the target several
times, it is probably scrap metal.
6. False signals can be caused by contaminated ground, electrical interference, or
large irregular pieces of metal. False signals are usually intermittent or not
repeated.
FACTORS AFFECTING OBJECT DETECTION:
It is difficult to obtain an accurate detection result. Factors that affect the quality of
readings are:
• the angle of the target buried in the ground,
the depth at which the target is located,
•
• the degree of oxidation of the target,
the size of the target,
•
• electro-magnetic and electrical interference surrounding the target,
measurements in the area of strongly mineralized soil, fertile ground or wet
•
sand - the detector will emit sound even if there is no metal in it. In this case
you can reduce the sensitivity. You can also increase the distance between the
probe and the ground,
metal digging tools placed near the unit.
•
TABLE OF METALS, TARGET IDENTIFIERS:
Iron
IRON
iron
Targe
object
t
s, gold
flakes
Icon
FOIL NI/5¢
aluminu
m,
Aluminu nickel,
m foil small
gold
objects
Gold
ALUM ZN/1¢
zinc,
aluminu aluminu
m, some
small medium-
sized
gold
items,
can pull
objects,
tabs, bottle
tops,
DIME
DIME, QTR (quarter), 50¢ -
m,
coins used in the United
States, silver coins, relics, large
items made of any type of
gold
Silver
QTR 50¢
metal