Fan Heater - DeLonghi 279798 Manual De Instrucciones

IMPORTANT:
The "Keypad Lock" function does not inhibit the
"Standby" button. This is therefore always active,
even when the "Keypad Lock" function is enabled.
GB

4.5.6 FAN HEATER

The "Fan Heater" function is only available on the radiators
equipped with fan heater. It is not available on this product.
command reception but it does not modify its current state.
ATTENTION:
on the display of the remote control.
4.6 OPERATION WITH THE STANDBY BUT-
TON ON THE SIDE CONTROL PANEL
The "Standby" button, located at the bottom of the remote
control housing on the side of the appliance (see Fig. 9), can
be used to turn the radiator on and off without the remote
control.
To turn the appliance on and off, press the "Standby" but-
ton. The radiator comes on in "Pilot Wire" mode and emits a
beep. The LEDs change colour accordingly (see page 16 for a
description of the colours). If the Pilot Wire is connected and
the programming unit is active, the appliance performs the
"Pilot Wire" order set on the programming unit. Otherwise it
performs the "Comfort" order.
The appliance emits a double beep when it enters the
"Standby" mode and a single long beep when it exits the
"Standby" mode.
When the radiator is turned on using the "Standby" button
on the side control panel, the "Comfort" temperature is set at
19°C and all functions are reset to the default values.
To go back to controlling the appliance using the remote
control, turn the radiator on using the "Standby" button on
the remote control. The appliance starts operating with the
modes, temperatures and functions set on the remote con-
trol.
IMPORTANT: After using the "Standby" button on the side
control panel, the appliance ignores all orders transmitted
by the remote control other than "Standby" and emits three
beeps to indicate the error.
IMPORTANT: In case of power down due to a black-out, all
the current settings are kept in memory for about 1 hour
and a half. At recovery from power down after 1 hour and a
half, the appliance goes to the previously selected operating
mode, loosing the hour and day of the week.
If the power down happens when the radiator is in "Chrono"
mode and the recovery takes place after 1 hour and a half,
the appliance goes to "Comfort" mode with temperature set
point 17 °C.
mand is sent from the RCU.
IMPORTANT: If the appliance remains without power
while the "Overdrive (2h)" function is enabled, the time
remaining until the end of the two hour period is retained
for about one and a half hours. After this time, when power
is restored the date and time settings are lost. The appli-
ance exits the function and operates in the mode selected
previously.
5. CLEANING
Before cleaning, make sure the appliance is turned
off, cold and disconnected from the household
mains.
To clean, just wipe with a soft damp cloth and
neutral detergent. Never use abrasive or corrosive
cleaning products or solvents.
surface and inside of the appliance at least twice a
year using a vacuum cleaner.
6. MAINTENANCE
Should any technical problems arise, contact a
by the dealer or manufacturer) or your local dealer.
All operations on the appliance must be carried out
ing maintenance must make sure the appliance is
turned off, cold and disconnected from the house-
hold mains.
The appliance contains a precise quantity of oil.
All repairs requiring the appliance to be opened
the event of oil leaks, contact your local dealer or a
22
-
-