Operating Modes - DeLonghi 279798 Manual De Instrucciones

TURNING ON FOR THE FIRST TIME
After inserting the batteries, set the day of the week and
time.
GB
Adjust the day of the week by using the "+" and "-"
pressing the "Mode" selection key.
just the hour by using the "+" and "-" keys and
Repeat the same procedure for the minutes.
4.3 ON/STANDBY MODE
In "Standby" mode the current time and the
day of the week appear on the display.
All the operating modes are suspended ("Pilot
Wire" included), but the appliance is powered
and waiting for command reception.
To turn the appliance on or off, press the "Stand-
by" button.
The radiator turns on in the previously selected
operating mode and emits a sound.
batteries, the "Comfort" mode is selected.
The entry into "Standby" mode is signalled by
means of a double beep, the exit from "Standby"
mode by means of a long beep.

4.4 OPERATING MODES

The appliance provides 5 operating modes
which allow the user to heat the environment
in the most suitable way with respect to his
needs.
Press the "Mode" selection key to select the
desired operating mode. An icon on the LCD
will show the selected operating mode.
Pilot Wire
Night/Eco
Chrono
PILOT WIRE
The temperature depends on the "Pilot Wire"
command.
All "Pilot Wire" commands are enabled.
-
Comfort
Anti-Freeze
18
COMFORT
The "Comfort" temperature corresponds to the tem-
perature desired by the user.
All "Pilot Wire" commands are disabled.
NIGHT/ECO
The "Night/Eco" mode keeps a comfortable tem-
perature with a reduced energy consumption.
All "Pilot Wire" commands are disabled.
ANTIFREEZE
In the "Anti-Freeze" mode the temperature set point
The appliance starts heating automatically when
the room temperature drops below 7 °C.
All "Pilot Wire" commands are disabled.
CHRONO
In this mode, you can select one of the three pre-
set chrono-thermostat programs or the custom
program. The latter lets you set a daily and weekly
program with two temperature levels ("Comfort"
and "Night/Eco").
All "Pilot Wire" commands are disabled.
4.4.1 PILOT WIRE
To activate the "Pilot Wire" mode:
Press the "Mode" selection key until the icon
appears on the LCD.
On the appliance the upper LED turns red.
Users can only set the "Comfort" temperature
on the remote control.
Select the desired temperature set point by
using the "+" and "-" keys.
porting this type of technology. In this case, correct trans-
ing the following diagram according to the mode set:
Night/Eco
Mode Comfort (Comfort Anti-Freeze Standby
-3,5 °C)
Signal to be
transmitted
Voltage
between
Pilot Wire 0 volt 230 volt
Negative
and neutral
wires
Comfort Comfort
-1 °C -2 °C
230 volt For 230 volt For
115 volt 115 volt
an interval an interval
Positive
of 3 s of 7 s
-
-